C123A ESP system sensors calibration
May 30, 2017
Add Comment
C123A ESP system sensors calibration - This Diagnostic Trouble Codes (DTC) is a generic code, which means that is applies to OBDII equipped vehicles including but not limited to Jeep Wrangler (JK), Grand Cherokee (WK), Cherokee (KL), Dodge (JC), Chrysler, Mercedes-Benz, BMW, Ford, VW, Chevrolet, Audi, Toyota, Honda, Hummer, Jaguar, Lexus, Volvo, Mazda, Mitsubishi, Nissan, Cadillac, GMC, Hyundai, Infiniti, Kia, Mini, etc.
If the calculated checksum does not match stored checksum.
If the calculated checksum does not match stored checksum.
Possible causes C123A code:
- Antilock Brake System (ABS) Module.
Diagnose C123A-ESP system sensors calibration
Step 1. Initialize Antilock Brake System (ABS) Module
Initialize ECU refer to ABS verification test.
Does this DTC reset ?
Yes, replace the Antilock Brake System (ABS) Module. Perform the
ABS Verification Test.
No, test complete for the DTC C123A-ESP System sensors calibration.
No, test complete for the DTC C123A-ESP System sensors calibration.
0 Response to "C123A ESP system sensors calibration "
Post a Comment