C2202 DODGE, JEEP, CHRYSLER, Original VIN Mismatch/Missing

C2202 code - At power up, VIN is read off the CAN bus. The VIN stored in the ABS Module does not match the VIN read off of the CAN bus.

Possible causes C2202 code

• ABS Module from different vehicle.
• ABS Module.
• Wrong VIN programmed into vehicle.

Diagnose DTC C2202 Original VIN Mismatch/Missing

Step 1. Check for a DTC C2202 Original VIN Mismatch/Missing

This DTC must be active for the results of this test to be valid. Turn the ignition on, with the scan tool, read DTCs. With the scan tool, read and record environmental data to help identify the conditions in which the DTC was set. Perform ECU initialization with drive test. Refer to ABS Verification test. Start the engine, with the scan tool read DTCs.

Does the scan tool display C2202 Original VIN Mismatch/Missing?

YES, go to step 2.
NO, Perform the ABS Intermittent condition, see this site label intermittent problems.

Step 2. Wrong VIN programmed into vehicle

Is the correct VIN programmed into the vehicle?

YES, replace the Antilock Brake System (ABS) Module. Perform the ABS Verification Test.
NO, reprogram the VIN per service information.

Test complete for DTC C2202 Original VIN Mismatch/Missing

Share this post