C1210 G Sensor Input Circuit Performance
January 16, 2018
Add Comment
When monitored code C1210 G sensor input circuit performance
Continuously, with ignition on, until vehicle speed exceeds 20 km/h (12.4 mph) for the first time, but not if the sensor voltage is out of range. Or, during diagnostic mode or if the monitoring was inhibited by a corresponding diagnostics command.
Set condition code C1210 G sensor input circuit performance, if the measured acceleration signal is higher than 0.8 g for longer than the specified detection time.
Continuously, with ignition on, until vehicle speed exceeds 20 km/h (12.4 mph) for the first time, but not if the sensor voltage is out of range. Or, during diagnostic mode or if the monitoring was inhibited by a corresponding diagnostics command.
Set condition code C1210 G sensor input circuit performance, if the measured acceleration signal is higher than 0.8 g for longer than the specified detection time.
Possible causes code C1210 G Sensor Input Circuit Performance
- Dynamics sensor installation
- Dynamics sensor.
Check for a DTC C1210 G sensor input circuit performance
This DTC must be active for the results of this test to be valid.
Turn the ignition on, with the scan tool read and record DTCs. With the scan tool, read and record environmental data to help identify the conditions in which the DTC was set. With the scan tool erase DTCs, cycle the ignition switch from to on and read DTCs
Does the scan tool display code C1210 G sensor input circuit performance?
YES, replace the dynamics sensor. Perform the ABS verification test.
NO, perform the ABS verification test.
Test complete for code C1210 G Sensor Input Circuit Performance.
0 Response to "C1210 G Sensor Input Circuit Performance"
Post a Comment