U1404 Implausible Static Engine Torque Signal Received
U1404 code - The messages sent on the Can bus are distinguished by an identifier (id). Each Can id is defined to contain a certain number of bytes. The transmission control module (TCM) verifies that it has received the proper number of bytes for each id. When monitored this DTC continuously with the ignition on, one valid can id received at least once, and no U0002 can bus off performance dtc present. Set condition this DTC when the TCM detects an incorrect can id from the ECM/PCM.
Possible causes U1404 code:
- TIPM Can Bus DTCs present
- ECM/PCM DTCs present
- Transmission control module
Diagnostic test U1404 code
step 1. Check for TIPM Can Bus DTCs
With the scan tool, read TIPM DTCs.
Are there any TIPM CAN BUS DTCs present?
Yes, Perform NAG1 Transmission Verification Test.
No, go to step 2.
Step 2. Check if engine DTCs are present
With the scan tool, read engine DTCs.
Are there any engine DTCs present ?
Yes, perform NAG1 Transmission Verification Test.
No, using the schematics as guide, check the transmission control module (TCM) terminals for corrosion, damage, or terminal push out. Pay particular attention to all power and ground circuits. If no problems are found, replace the TCM in accordance with the service information. Perform NAG1 Transmission Verification Test.
0 Response to "U1404 Implausible Static Engine Torque Signal Received"
Post a Comment